---
title: "Auto-tuning"
id: "auto-tuning"
project: "Clean Power VFD User Guide"
url: "https://smartd.clickhelp.co/articles/clean-power-vfd-publication/auto-tuning"
updated: 2026-10-29T18:46:34Z
---

# Auto\-tuning

[Home](/articles/clean-power-vfd-publication/home) » [Functions and parameters](/articles/clean-power-vfd-publication/folder-functions-and-parameters) » Auto-tuning

* * *
 
Auto-tuning is an intelligent function of the Clean Power VFD that allows the refinement of the motor parameters and maximizes the performance of the whole power drive system.

## Pre-requisite

Auto-tuning can be run when:

1. The variable frequency drive is in the “ready to run “ state.
2. The motor is at a standstill.
3. The motor is at ambient temperature.
4. The motor's parameters are set correctly at the motor nameplate values and downloaded in the VFD

If the VFD is not in the “ ready to run state” or if the back EMF from the motor shows that the motor is spinning, the user can not start the auto-tuning function.

## Procedure

The user can initiate the motor auto-tuning process via the mobile App or the HMI:

From the dashboard, tap on the hamburger in the upper right corner of the screen to open the menu.

![](/resources/Storage/clean-power-vfd-publication/screenshotmobileappshowtheelleipsis.png)

Then select "Configuration", and "Motor Auto-Tuning"

When the auto-tuning wizard screen is displayed, tap on the "start".

The auto-tuning starts, and the procedure step is shown by its radio button.

After 5 seconds, the auto-tuning is complete, and the following step, "review the parameters" is accessible.

In case of an error, the application shows an error modal when pressing the icon **!**

When the user leaves the error modal, the application goes to the done state, and the user can start a new auto-tuning sequence by tapping the "retry" button.

When done with success, the user can save and apply the motor values by tapping on the button "Apply"