---
title: "Maintenance: Safety messages"
id: "maintenance-safety-messages"
project: "Clean Power VFD User Guide"
url: "https://smartd.clickhelp.co/articles/clean-power-vfd-publication/maintenance-safety-messages"
updated: 2026-10-29T18:46:16Z
---

# Maintenance: Safety messages

[Home](/articles/clean-power-vfd-publication/home) » [Maintenance](/articles/clean-power-vfd-publication/maintenance) » Maintenance: Safety messages

* * *
 
![](/resources/Storage/clean-power-vfd-publication/res/Safety%20picture%20Red%20Danger.png)

* Maintenance and inspection can only be performed by skilled professionals.

Risk of personal injury.

* Maintain and inspect devices after power is off.

Risk of electric hazard.

* Repair or maintain the AC drive after a minimum of 5 minutes have passed since it is powered off.

This allows for the residual voltage in the capacitors to discharge to a safe value.

Failure to comply will result in personal injury.

* If you replace the Clean Power VFD with a new one, set and check the parameters again after the AC drive is replaced.

Failure to comply will result in personal injury.

* * *
![](/resources/Storage/clean-power-vfd-publication/res/Safety%20picture%20Orange%20Warning.fr-CA.png)
* The VFD becomes hot during operation.

Avoid touching the VFD until it has cooled to avoid burns.

* * *
![](/resources/Storage/clean-power-vfd-publication/res/Safety%20picture%20Yellow%20Caution.png)
* Lock out and tag out all potential energy sources before working on the Clean Power VFD.
* Before inspecting the product, read all safety instructions in this manual.
* Before you clean the product, ensure that the power is off.
* Clean the Clean Power VFD with a dry cloth. Cleaning with wet cloths, water, solvents, or detergents may result in electric shock or damage to the product.
* When a motor is used for the first time or when a motor is reused after being kept unused for a long time, or when a periodical inspection is performed, an insulation inspection shall be conducted, so as to avoid damaging the Clean Power VFD because of the insulation failure of the motor windings.
* During the insulation inspection, the motor wires must be disconnected from the Clean Power VFD.
* It is recommended to use a 500V mega meter, and the insulating resistance measured shall be 5MΩ.