Home » Installing the VFD » Mechanical installation » Mechanical installation: Safety messages.
- Do not install the Clean Power VFD in an environment containing explosive gases.
Risk of explosion.

- The installation base shall be made of metal or other non-flammable materials.
Risk of fire.
- Do not unscrew the fixing bolts.
The Clean Power VFD may fall, risk damaging it and other surrounding products, as well as risk losing the cable connections, with subsequent risk of short-circuits
- Do not leave cable strips or screws in the Clean Power VFD.
Risk of Clean Power VFD damage.
- Ensure that foreign materials, such as metal shavings or wire fragments, cannot fall into the VFD during installation.
Place temporarily a cover over the VFD during installation, but remove it before use to ensure proper ventilation and avoid overheating the VFD.
Risk of damage to the VFD.
- Ensure the ambient temperature will never exceed the allowable range while operating the drive.
Risk of damage to VFD.
- Install the product in a location with minimal vibration and out of direct sunlight.
Risk of damage to VFD.
- If two or more Clean Power VFDs are installed in the same enclosure, ensure that there is sufficient ventilation to ensure proper cooling of all the devices.
Risk of damage to the VFD.
- Failure to respect the minimum mounting clearances may cause the Clean Power VFD to overheat, potentially reducing the operational lifespan of the VFD and/or voiding the warranty.
- Do not install the Clean Power VFD on the floor or mount it sideways against a wall.
- The VFD must be installed vertically on a wall or inside a panel, with its rear flat on the mounting surface.