Home » Functions and parameters » Motor Control Mode » Motor frequency (Hz) - Velocity (RPM) » Motor velocity setpoint
SmartDrive provides several ways to set up and modify the velocity (RPM) setpoint.
- The embedded HMI,
- the SmartDrive App,
- the analog inputs,
- the preset speeds,
- and the remote control from the Ethernet connection.
Set the velocity setpoint from the Clean Power VFD analog input.
Analog inputs from AI1 to AI3 can be assigned to be the velocity setpoint input. By default, the analog input AI1 is the velocity setpoint.
Analog signals can be set by software to be either a potentiometer input, a 4 to 20 mA input, or a 0 to 10 VDC input. By default, the analog input AI1 is set as a potentiometer input.
A +10V voltage output on the control terminal is the reference value.
From the SmartDrive app, the user can define the conversion scale from the analog signal to the velocity by defining the minimum and maximum velocities.
Any value change on this input will be read instantaneously by the Clean Power VFD and become the reference setpoint.
The frequency output will vary immediately from the actual velocity to the new velocity; defined by the setpoint.
A change of the setpoint value from the analog input is displayed on the Clean Power VFD's HMI.
|
If the motor velocity does not reach the set value: Check the most common following causes:
|